KYOCERA KM-P4850w Bedienungsanleitung PDF herunterladen (Seite 57)

CHAPTER 6 TROUBLESHOOTING

6-11

6. Troubleshooting

Refer to the following chart if trouble occurs. If trouble persists, contact your service representative.

TROUBLE

The main switch is on but

nothing is displayed on the

operation panel.

Nothing is being printed out

CHECK POINT

Is the power cord connected

properly?

Is the power cord connected

properly?

Is the main switch to the printer

turned ON?

Is the network cable appropriate and

is it connected properly?

Was the network cable connected

AFTER the power to the printer was

turned ON?

Is the printer off-line?

(Is “Off line.” displayed?)

Was printing initiated immediately

after the main switch was turned ON

( | ) to the printer?

Are the IP addresses for the printer

and/or the corresponding computer

(device) name and host name

correctly registered in your

computer?

PROCEDURE

Make sure that the power cord is securely inserted

into an outlet.

Make sure that the power cord is securely inserted

into an outlet.

Make sure that the main switch is turned ON ( | ).

Make sure that an appropriate network cable is

being used and make sure that it is connected

properly.

Always connect the printer cable BEFORE turning

the power to the printer ON.

Press the On Line key in order to put the printer

back on-line. Once it is back on-line, the Ready

indicator will light.

Even though the printer’s warm-up may have been

completed, the internal computer that manages

printing and scanning may still be starting up. Wait

approximately 2 minutes or so and try again.

Make sure that the settings in the printer driver and/

or the software application being used are correct.

PAGE

—

3-2

—

2-4

—

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

KYOCERA KM-P4850w Bedienungsanleitung Seite 57

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laser- / LED-Drucker KYOCERA KM-P4850w