KYOCERA KM-P4850w Bedienungsanleitung PDF herunterladen (Seite 26)

CHAPTER 3 GETTING READY FOR PRINTING

3-8

Grasp both paper roll insertion latches 3 and open the

paper roll insertion cover 4.

Insert the leading edge of the paper under the paper roll

insertion guide and advance the edge past the guide

approximately 1/2" [10 mm] as shown in the illustration.

NOTE

If the leading edge of the paper roll is folded or broken, cut a clean

edge using a cutter.

Grasp the paper roll insertion latches and close the paper roll

insertion cover securely.

1/2"

[10mm]

IMPORTANT

If the paper roll that has been set is slackened, grasp the flange and

wind the paper roll to remove the slack. If not, the paper may be fed

obliquely.

Insert the roll unit securely into the main body of the

machine.

Close the front cover.

To align the leading edge of the paper roll, use the N or M

key to select a paper tray and press the Roll Cut key. The

leading edge of the paper roll will be ejected from the paper

eject slot.

NOTE

• Paper is normally cut in lengths of 11" [279 mm]. If the temperature

in the machine is lower than 15 °C, however, vellum will be cut in

lengths of 31" [800 mm].

• When a paper roll has been replaced during printing, press the On

Line key to place the printer offline and then press the Roll Cut key.

To continue printing press the On Line key once more to place the

printer online.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

Keine Kommentare

KYOCERA KM-P4850w Bedienungsanleitung Seite 26